Type: Estane® R195A is aromatic, polyether-based thermoplastic polyeurethane (TPU).
Features: Excellent physical properties, low temperature performance and clarity with a wide processing window for extrusion.
Uses: Blown and flat die/cast film extrusion. Injection and blow molding.
| Original Document | Technical Datasheet(English) | |||
| Availability | Asia | |||
| Features | High Impact at Low TemperaturEasy processing | |||
| Processing | InjectionExtrusionFilm ExtrusionBlow Molding | |||
| Compliance | FDA | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Abrasion resistance | *** mg/1000cy | ASTM D 3389 | 1000 rev |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Strength | |||
- | *** Mpa | ASTM D 412 | |
at 100% strain | *** Mpa | ASTM D 412 | |
at 300% strain | *** Mpa | ASTM D 412 | |
Tensile Elongation | |||
Break | *** % | ASTM D 412 | |
Tear Strength | *** N/mm | ASTM D 624 | Graves |
Tear Strength | *** N/mm | ASTM D 470 | Trouser |
Tensile Set | *** % | ASTM D 412 | 200% elongation |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Shore A hardness | *** A | ASTM D 2240 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Melt Temperature(Tm) | *** °C | Internal | |
Melt Temperature(Tm) | *** °C | Internal | Kofler Melt Point |
Glass Transition Temperature | *** °C | Internal |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
