CYREX 200-8005 alloy is an opaque, acrylic-polycarbonate alloy with an impact strength that is higher than polycarbonate for molding and extrusion medical applications.
Typical properties of CYREX® acrylic-polycarbonate alloys are:
outstanding impact strength and toughness
excellent processing characteristics
very good chemical resistance
good heat resistance
The special properties of CYREX 200-8005 alloy are:
medium melt flow rate
excellent resistance to both alcohol and lipids
good resistance to EtO, gamma and E-beam sterilization
Application:
Used for injection molding and extrusion of both thin and thick wall applications which require excellent toughness.
| Original Document | Technical Datasheet(English) | |||
| Features | High ImpactGood ToughnessHeat ResistanceEasy processingFood ContactMedical Application/Health CareE-beam SterilizableGamma ResistanceEtO sterilizableChemical ResistanceOil ResistantAlcohol ResistantLipid Resistance | |||
| Appearance | Pellets/GranulesOpaque Color | |||
| Processing | InjectionExtrusion | |||
| Compliance | FDAISO10993USP Class VI | |||
| Physical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
|---|---|---|---|
Density/Specific Gravity | *** g/cm³ | ASTM D792 | |
Melt Mass Flow Rate(MFR) | |||
230°C/3.8 kg | *** g/10 min | ASTM D 1238 | |
Mold Shrinkage | |||
- | ***~*** % | ASTM D955 | |
Water Absorption | *** % | ASTM D570 | |
Bulk(Apparent ) Density | *** g/cm³ | ASTM D 1895 | |
| Mechanical | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Tensile Modulus | *** Mpa | ASTM D638 | |
Tensile Strength | |||
- | *** Mpa | ASTM D 638 | |
Tensile Elongation | |||
Yield | *** % | ASTM D638 | |
Break | *** % | ASTM D638 | |
Flexural Modulus | *** Mpa | ASTM D790 | |
Flexural Strength | |||
- | *** Mpa | ASTM D790 | |
| Impact | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Izod Notched Impact Strengh | |||
23℃ (73℉) | *** J/m | ASTM D256 | 3.18 mm |
| Hardness | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Rockwell M | *** M | ASTM D 785 | |
| Thermal | Value/Unit(Sign in to View) | Test Standard | Test Condition |
Heat Deflection Temperature(HDT) | |||
1.8 Mpa (264 psi)（18.6kg/cm²） | *** °C | ASTM D648 | Annealed, 6.35 mm |
Vicat Softening Temperature(VST) | *** °C | ASTM D1525 | |
Coefficient of Linear Thermal Expansion | |||
- | *** E-6 mm/mm/℃ | ASTM D 696 | 0 to 100°C |
The information presented on this datasheet was acquired by AjiEng.com from the producer of the material. AjiEng.com makes substantial efforts to assure the accuracy of this data. However, AjiEng.com assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.
